Bernat SofteeBabyweb25 cr blanket.en US, 29.08.2012, Nowy folder

[ Pobierz całość w formacie PDF ]
™
HAIRPIN LACE BABY BLANKET
| Crochet
MEASUREMENTS
Approx 35" x 45" [89 x 114.5 cm].
MATERIALS
Bernat® Softee® Baby™
(140 g/5 oz; 331 m/362 yds)
Aqua (30201)
4 balls
Size 4 mm (U.S. G or 6) crochet hook. Hairpin Lace Loom.
ABBREVIATIONS
www.bernat.com/abbreviations
Approx
= Approximately
Rep
= Repeat
To g
= Together
Yoh
= Yarn over hook
HOW TO "HAIRPIN LACE"
(Check out our video at: http://www.bernat.com/videos/#crochet)
BASIC STRIP
1.
Set loom to width indicated in pattern.
2.
Wrap yarn around the back of loom, placing yarn end on left
side of the loom and working yarn on right side.
3.
Bring working yarn to front of loom, crossing over to left side
of loom.
4.
Bring yarn end to front of loom, crossing over to right side of
loom. This should form an “X”.
5.
Wrap yarn end around bottom of “X” to the back, around all
yarns and then bring back to the front of loom.
6.
Tie a knot around “X” using the yarn end and working yarn.
Make sure knot is centered. Drop yarn end.
7.
Holding working yarn, cross over to right side of loom,
wrapping to the back.
8.
Insert hook into left loop from the bottom, yoh and draw up
a loop.
9.
Yoh and draw through all loops on hook.
10.
Keeping working loop on hook,
ip hook to back of loom
(through the loom and over the top of work).
11.
Hold working yarn in left hand and rotate loom, bringing right
side to left side. Working yarn will now be wrapped around
right side of loom, ready for the next stitch.
www.bernat.com
HAIRPIN LACE BABY BLANKET
1 of 2
P.O. Box 40, Listowel ON N4W 3H3
“home style… life style… your style.”
                   ™
HAIRPIN LACE BABY BLANKET
| Crochet
12.
Insert hook in upper left loop. Yoh and draw up a loop.
FINISHING SIDE EDGES
1.
Insert hook into
rst 8 loops of Strip.
13.
Yoh and draw through all loops on hook.
2.
Draw last 4 loops on hook through
rst 4 loops on hook.
14.
Rep Steps 10-13 required number of times. Mark every 30
loops for easier counting.
3.
Insert hook into next 4 loops of Strip and draw through 4 loops
on hook.
15.
To
nish Strip, break yarn, leaving a long tail and thread
through remaining loop on hook.
4.
Rep Step 3 until end of Strip.
5.
Using a piece of scrap yarn, secure end temporarily so Strip will
not unravel.
16.
Remove Strip from loom and roll Strip from the top to the
bottom, until ready to use.
Rep on opposite side edge.
BASIC JOINING TECHNIQUE
Joining Strips 1 and 2
(starting with a left strip)
1.
BLANKET
Set loom to 4" [10 cm] wide.
Make 20 Basic Strips of 160 loops.
Join Strips tog using Basic Join Technique.
Finish side edges as per Basic Instructions.
Add Fringe to top and bottom of Blanket.
Lay 2 Strips side by side on a
at surface and unroll slightly.
2.
Working with Strip on the left, insert hook through
rst 4 loops
on right side of Strip.
3.
Working with Strip in the right, insert hook through
rst 4
loops on left side of Strip and draw through 4 loops on hook.
Fringe
Cut 12" [30.5 cm] lengths of yarn. Taking 3 strands tog, knot into fringe
evenly across top and bottom of Blanket. Make sure to loop fringe
through both working loops along top edge so Blanket will not unravel.
Trim ends evenly.
4.
Insert hook through next 4 loops of left Strip and draw through
4 loops on hook.
5.
Insert hook through next 4 loops of right Strip and draw
through 4 loops on hook.
6.
Unrolling Strips as needed, rep Steps 4 and 5 until end of Strip.
7.
Using a piece of scrap yarn, secure end temporarily so Strip will
not unravel.
Joining Strips 2 and 3
(starting with a right strip)
1.
On a
at surface, lay Strip 3 to the right of joined Strips 1 and
2. Unroll slightly.
2.
Starting with the Strip on the right (Strip 3), insert hook in
rst
4 loops on left side of Strip.
3.
Working with Strip on the left (joined Strips 1 and 2), insert
hook through
rst 4 loops of right side of Strip and draw
through 4 loops on hook.
4.
Insert hook though next 4 loops on right Strip and draw
through 4 loops on hook.
5.
Insert hook through next 4 loops on left Strip and draw
through 4 loops on hook.
6.
Rep Steps 4 and 5 until end of Strip.
7.
Using a piece of scrap yarn, secure end temporarily so Strip will
not unravel.
Continue joining Strips as established, making sure to alternate
starting with a left strip or right strip otherwise work will begin to slant.
www.bernat.com
HAIRPIN LACE BABY BLANKET
2 of 2
P.O. Box 40, Listowel ON N4W 3H3
“home style… life style… your style.”
                  [ Pobierz całość w formacie PDF ]

  • zanotowane.pl
  • doc.pisz.pl
  • pdf.pisz.pl
  • braseria.xlx.pl

    •